24
OPERATION
Model VFF-PH(32DR)(32DR-H)(FSDR-2C)
1. STOP! Read the safety information to the left on this label.
2. Open the lower access panel located below the fireplace screen.
• Set receiver switch to “ON” position (See Fig. 17).
3. Turn control knob clockwise to the “OFF” position (See Fig. 17).
4. Wait five (5) minutes to clear out any gas. Then smell for gas, including
near the floor. If you smell gas, STOP! Follow “B” in the safety information
to the left on this label. If you don’t smell gas, go to the next step.
5. Push in slightly and turn control knob counterclockwise to the
“PILOT” position (See Fig. 17). Depress control knob.
6. With control knob depressed, push down on the ignitor button until the
pilot lights. The pilot is located behind the fireplace screen, centered near
the rear of the burner (See Fig. 18).
7. Keep control knob depressed for (30) seconds after pilot lights. Release
control knob.
• If the control knob does not pop up when released, stop and immediately
call a qualified service technician or gas supplier.
• If pilot goes out repeat steps 3 through 7. Wait (1) minute before attempting
to light pilot again. If after several tries the pilot still goes out, turn the
gas control knob clockwise to the “OFF” position and call a qualified
service technician.
8. Turn control knob counterclockwise to the “ON” position.
9. To use the included thermostatic remote control, set receiver switch to
the “REMOTE” position (See Fig. 19). Press the ON button to turn on the
remote to ignite the main burner. Refer to the remote control’s included
instruction manual for “MODE” and “SET” functions.
ON
OFF
REMOTE
LEARN
TO TURN OFF GAS TO APPLIANCE
Models VFF-PH(20D)(20D-C)(CPD-2T) & VFF-PH(26D)(26D-T)(IMD-2H)
1. Open the lower access panel located under the fireplace screen.
2. Turn control knob clockwise to the “OFF” position.
3. Close lower access panel.
Model VFF-PH(32DR)(32DR-H)(FSDR-2C)
1. Set thermostat to the lowest setting.
2. Press the OFF button on the remote control.
3. Open the lower access panel located under the fireplace screen.
4. Push in slightly and turn control knob clockwise to the “OFF” position.
5. Close lower access panel
.
Fig. 17 - Receiver
& Control Knob
ON
OFF
MODE
SET
Fig.19 - Remote
Fig. 18 - Pilot
