pleasant hearth 23-700-712, Важное руководство по инструкциям

Страница: 12 / 58

12
2
3
1
The infrared remote control relies on a line of sight and must be pointed at the flame/screen of the
fireplace to work. The remote control unit has the controls required to turn ON/OFF both the main
power and the heater. If you prefer to use the touchpad control on the fireplace unit itself,
open the control panel sliding cover to access the touchpad buttons. The layout of the buttons
on touchpads and remote control unit can be seen in figures 3 and 5, respectively.
1. Plug your fireplace into a 15-amp, 120-volt power outlet.
2. Turn the power on. Flame will show on the back screen
of the fireplace.
3. Remove plastic tab from inside battery compartment
to activate remote control.
4. Point the remote control directly at the fireplace
flame/screen and use the buttons to operate the
fireplace.
Main Power Button:
This button supplies power to all the functions of the
fireplace. The main power button must be in the
ON
position, either from the remote or on the touch pad
for the functions to work.
Heater Control Button:
This button controls the heater ON/OFF and
5 temperature modes from low to high. When
the heater is first turned on, the heater will come on at
the lowest room temperature setting. The fireplace will
remember the last heat setting and in later use the heater
will start at that setting, unless power to the unit has been
interrupted. Each time the temperature button is pressed,
the temperature set point increases, allowing you to adjust
the ambient temperature.
Flame Control button:
This button controls the brightness of the flame effect with
settings at high, medium and low. When the fireplace is first
turned on, the flame will come on at the highest setting. The
fireplace will remember the last flame setting used and in
later use the flame brightness will start at that setting, unless
power to the unit has been interrupted. Each time the flame
button is pressed, the flame brightness decreases. The only
way to turn off the flame effect completely is to turn off the
main Power button.
The plastic tab inside the battery
compartment MUST be removed
before remote control will operate.
OPERATING INSTRUCTIONS
1
2
3
(Pull tab)
4
5