12
TD-000368-01-A
WARNING!:
When the AC Power is on, there is a potential of having dangerous voltage at the output terminals on the rear of
the amplifi er. Use caution not to touch these contacts. Turn off the AC Mains disconnect switch prior to making any connections.
IMPORTANT:
QSC recommends that you connect jumpers where the terminals are the same points electrically. Refer to
Figure 14
thru
Figure 22
.
1. Turn the AC Mains power switch to on. The amplifi er starts in the Run mode, or the last mode it was in before power was turned off.
2. Press and release the front-panel power button. The button fl ashes red, the amplifi er is in Mute All mode.
3. Select the confi guration appropriate for your loudspeakers, using either Preset Recall, or the Preset Wizard.
The following is a list of confi gurations for 1-, 2-, 3-, and 4-channel outputs. This is not an exhaustive list, but is intended to give you an idea of what is
available and how the outputs would be wired.
One-Channel Confi gurations
— Figure 14 —
F9: ABCD
F9: ABCD
ABCD Parallel
1
ABCD
A
C
B
D
X
Y
1-
1+
1-
1+
1+
1-
1-
1+
The following are electrically
the same point
A. B, C, and D, (1+)
A, B, C, and D, (1-)
You can use any, or all of the
connectors A, B, C, and/or D.
= Subwoofer
— Figure 15 —
F8: AB+CD
F8: AB+CD
AB in Parallel
Bridged with
CD in Parallel
1 AB+CD
B
X
A
C
D
Y
= Subwoofer
1+
1-
Two-Channel Confi gurations
— Figure 16 —
F6: A+B C+D
F6: A+B C+D
A+B Bridged
C+D Bridged
The following are electrically
the same point
X (2+) and Y (1+)
X (2-) and Y (1-)
Optional
1 A+B
3 C+D
A
B
X
= Subwoofer
C
D
Y
1+
1-
2+
2-
1+
1-