Model XX0598
ECN2218
Page 11 of 14
Installation Instructions
Attach the seat mounting brackets to the frame.
__Step 11:
Attach the seat mounting brackets to the frame. See
Detail H
. Select
the (8) eight seat mounting brackets, (8) eight pieces of plastic trim and appropriate
hardware. There are (24) twenty four lower connections and (16) sixteen upper
connections. Position a bracket and piece of plastic trim against each end of the
see-saw frame and, using loctite on the 1" bolt threads only, make attachments
as shown.
Note
: Four of the mounting brackets and plastic trim are designed to be mounted
on the left side of the see-saw frame and four on the right side. Hole patterns are
distinct and brackets can only be mounted on the correct side.
Attach the handle side panels to the frame.
__Step 12:
Attach the handle side panels to the frame. See
Detail I
. Select
(8) eight handle side panels and appropriate hardware. There are (16) sixteen
connections. Position each side panel against the see-saw frame just ahead of
each seat mounting bracket. Apply loctite to the bolt threads and make attachments
as shown. Leave the connections loose.
Note
: Ensure the handle side panels angle towards the seat mounting bracket.
Attach the handles to the side panels.
__Step 13:
Attach the handles to the side panels. See
Detail J
. Select (8) eight
handles and the appropriate hardware. There are (32) thirty two connections.
Position each handle between the top or bottom of each pair of side panels and
make attachments as shown.
Attach the seat covers to the seat mounting bracket.
__Step 14:
Attach the seat covers to the seat mounting bracket. See
Detail K
.
Select (4) four seat covers and the appropriate hardware. There are (16) sixteen
connections. Position each seat cover, with the countersunk holes up, over the
bottom of the seat mounting brackets and make attachments as shown.
Attach the seat covers to the seat back.
__Step 15:
Attach seat covers to the seat back. See
Detail L
. Select (4) four
seat covers and the appropriate hardware. There are (16) sixteen connections.
Position each seat cover, with countersunk holes out, against the seat backs and
make attachments as shown.
Final Details.
__Step 16:
Plumb and level entire component. Tighten
all
fasteners. Fully tighten
all fasteners according to tightening torque specifi cations.
Torque Specifi cations:
Bolts and nuts
- Snug tighten and then tighten an additional one half turn.
Note
: Check for proper operation. Frame should pivot smoothly on the shaft.
__Step 17:
For areas complying with ASTM standard F1487 and CSA Z-614,
apply the age appropriate label at a visible location on the equipment. Also apply
the Surface Warning labels at the locations indicated on the
Elevation View
.
