6
Items for
STEP 5
:
(1) Ladder Assembly
(2)
³⁄₈
" x 1
¹⁄₄
" Hex Bolts
(2)
³⁄₈
" Flat Washers
Attach the ladder temporarily
to the dock as shown.
Make sure the ladder is resting
firmly against the top and side
of the dock. Temporarily insert
a
³⁄₈
" x 1
¹⁄₄
" hex bolt and a
³⁄₈
"
flat washer through the side
bracket to hold ladder in place
as shown.
Mark the two outermost holes of the two top brackets inside the groove of the Resin Dock Top as shown.
Remove the ladder from the dock and remove the two brackets installed temporarily on the ladder.
Items for
STEP 6
:
(2) Ladder Brackets
(2) Plate Washers
(4)
³⁄₈
" x 2" Carriage Bolts
(4)
³⁄₈
" Flat Washers
(4)
³⁄₈
" Lock Washers
(4)
³⁄₈
" Hex Nuts
At the previously marked locations, drill
³⁄₈
"
holes through the top of the dock.
Position ladder brackets on the top facing
each other and place plate washers at the
bottom as shown.
Secure using
³⁄₈
" x 2" carriage bolts,
³⁄₈
" flat
washers,
³⁄₈
" lock washers and
³⁄₈
" hex nuts
as shown. Do not over tighten.
NOTE
:
If you are installing the ladder on a floating dock, you will need to remove the float(s) located under the
brackets prior to this step. After completing this step, reattach the float(s).
Mark these holes
(both sides).
Tight against top
and sides.
