11
2. Assembly of the goal:
We recommend to mount the goal on the grass or on a suitable surface to avoid
damages of the profiles.
The following tools are necessary:
- 1 wrench/ring spanners 10 mm and 13mm
- 1 mallet/hammer
a) Lay bar/upright construction on the ground with guide rail showing upwards.
b) Stick from the bottom (u
pright’s end) 2 nuts 20 mm, M 8 each in the guide
rail of the upright and push them to the top.
Lay upper hinge with 2 fastening boreholes under the 90° elbow (at the top).
Please consider that the inclined side of the hinge points to the goal inside.
Push nuts 20 mm, M 8 below the boreholes of the hinge and tighten it with
safety hexagon socket screws DIN 7991, M 8 x 16.
c) To fix the lower hi
nge stick from the bottom (upright’s end) 1 nut 20 mm, M
8 each in the guide rail of the upright. Mount lower hinge with 1 fastening
borehole.
Please consider that the inclined side of the hinge points to the goal inside.
Push nut 20 mm, M 8 below the borehole of the hinge and fix it at the upright
with safety hexagon socket screw DIN 7991, M 8 x 16.
