ENGLISH
8). Position the back grill over the motor shaft, fitting the
holes in the back grill over the 4pcs screws holes that
outside of the motor. Make sure the handle is at the top.
9). Secure the back grill by screwing the 4pcs back grill
locking screws.
10). Loosen the securing screw on the pedestal fan blade.
Slide the pedestal fan blade onto the mounting shaft with
the shaft sleeve facing the motor. Align securing screw
with flat groove in the motor shaft and tighten with a
Phillips screwdriver.
11). Remove the small securing bolt from the bottom of the
front grill. Position front grill so the logo is horizontal and
make sure the grill clips are open. Secure the top tab to
the back grill. Fasten the grills together with securing
bolt. Hold the front grill against the back grill and snap
the grill clips closed to complete the assembly.
OPERATION INSTRUCTIONS:
1.
Turn the speed control to select speeds: 0(off) and speeds I (Low), II (Middle), III (High).
2.
The pedestal fan can operate in oscillation or stationary mode. Press the Oscillation Knob down
to activate the oscillating mode. To stop oscillation, pull the knob upward. To adjust the tilt of the
pedestal fan grasp the pedestal fan motor housing and gently push forward or backward.
The pedestal fan head can adjusts 30 degree tilt angle.
ADJUSTMENT INSTRUCTIONS:
l
To adjust the angle of the pedestal fan head, loosen the adjustable-tilt knob and move the
pedestal fan head to the desired angle. Firmly tighten the knob to secure into place.
l
To adjust the height of the pedestal fan, turn the adjustable height knob counter-clockwise to
loosen the stand. Adjust the pedestal fan to the desired height, then firmly tighten to secure
into place.
