Platinum AUPL-GF61SS, Руководство пользователя

Страница: 12 / 20

Page 12 Gas Hob User Manual
Installation
8. Connect the appliance to the gas supply
(refer to the ‘Gas Connection’ section).
9. Secure the appliance by matching the
screws with the correspondent screw holes
in each bottom corner of the cooktop.
10. Once the gas cooktop has been installed it
is essential to check that neither the gas pipe
nor the electricity cable is in contact with hot
parts of the appliance or hot gas exhaust.
NOTE //
A full operational test and a test for
possible leakages must be carried out by the
installer before leaving. Check all burner flames
are blue in colour, stable and completely ignite
at both high and low flame settings with no
appreciable yellow tipping, carbon deposition,
lifting, floating lighting back or objectionable
odour. Test burners individually and in
combination.
Electrical Connection
IMPORTANT //
Electrical connections should be
carried out by a suitably qualified and competent
person in strict accordance with the wiring rules
and national and local safety regulations.
Installation Procedure
1. Make the benchtop cut-out for the cooktop
in accordance with the diagrams previously
presented in this manual.
2. Remove trivets, gas burner caps and
diffusers.
3. Turn the cooktop upside down resting it on
a cloth.
NOTE //
Be careful not to damage the ignition
candles and the probes of the flame failure
device during this process.
4. Apply the self-adhesive seal strip onto the
edges of the cooktop that will be resting on
the benchtop. (Do not overlap the ends of
the seal strip)
NOTE // Do not use any joint sealant. The
appliance’s sealing strip ensures a sufficient seal
between the appliance and the benchtop.
5. Feed the flexible power cord down through
the cut-out.
6. Place the cooktop in the cut-out without
securing it.
7. Connect the appliance to the mains
electricity supply (refer to the ‘Electrical
Connection’ section).