Plantronics Savi User Guide
14
Out of range warning
If you are on a call, you will hear the audio degrade as you move
out of range.
If you stay out of range, active calls will be suspended. Calls will be
re-established when you walk back into range. If you remain out of
range for more than 10 minutes, the system will drop the call.
Low battery warning
A repeating high/low tone pair every 10 seconds indicates the
battery is low. You should recharge the headset immediately.
Checking the battery level
You can check the battery level by pressing the call control button
inwards then holding in the volume down position for 2 seconds.
The headset indicator will flash red to indicate the remaining
battery charge level.
One red flash = low charge level
Two red flashes = medium charge level
Three red flashes = high charge level
Turning the headset indicator blue flash
on/off
By default, the headset indicator flashes blue to indicate the
headset state as described in the section
Headset indicator
lights and tones
. This feature may be disabled by pressing the
call control button inwards then holding in the volume up position
for two seconds. The headset indicator will show a short burst of
blue flashes.
Repeat this operation to turn the headset blue flashing indicator
back on.
Mute warning
When mute is activated, you will hear a single low tone which will
repeat every 30 seconds.
Subscription
The headset and base unit are supplied subscribed to each other.
However, if you wish to use a replacement headset with your
existing base, the units can be subscribed to each other by the
following method:
1
ensure your replacement headset is fully charged.
2
Power the headset off by pressing and holding the call
control button for six seconds.
The headset indicator light
will be red for four seconds.
3
Place the headset in subscription mode by pressing and
holding the call control button until the indicator light
flashes red and blue.
4
Place the base in subscription mode by pressing and
holding the subscription button on the base for two
seconds, the subscription light will flash red and blue.
5
When the subscription light on the base goes solid blue,
the headset and the base are subscribed to each other.
