Use these steps to get set up quickly:
See Maintenance and Troubleshooting section on the other side.
3
5
2
1
Identify the
Components
Clothing Clip
The clothing clip keeps
the headset properly
seated and free from
the cord’s weight.
Attach the clothing clip
at a comfortable level.
Quick Disconnect
™
Connector
This feature allows you
to place a call on hold
and move away from
the phone without
removing the headset.
When you separate the
Quick Disconnect, you
place an ongoing
conversation on hold.
Before using your headset,
join the Quick Disconnect to the mating
connector of the modular adapter cable.
To put your call on hold, grasp Quick
Disconnect, as shown, and pull straight
apart. To resume your conversation,
reconnect the halves.
Adjust the
Headband
ENCORE
®
FAMILY OF HEADSETS
Adjust the
Tone Controls
Adjust the Mouthpiece
For Standard Models:
3.1
Hold the receiver securely
against your ear with one hand.
With your other hand, adjust the
clickstop turret and the voice tube
so that the tip sits two finger-
widths from the corner of your
mouth. (To prevent breath noise,
avoid putting the voice tube in
front of your mouth.)
For Noise-Canceling Models:
3.2
Carefully bend and shape the
boom with both hands as shown.
Avoid bending or twisting the
boom near the microphone or
earpiece.
3.3
Position the clickstop turret and
boom so that the microphone is
two finger-widths from the corner
of your mouth.
3.4
Make sure the front of the
microphone faces your mouth. If
necessary, twist the microphone
slightly so it's in the proper
position. Do not use forceful
twisting motions or try to turn the
microphone completely around.
Adjustable
Headband
Noise -Canceling
Microphone
Voice Tube
T- Bar
Receiver
Clothing
Clip
Quick Disconnect
™
Connector
4
Examine
the Additional
Features
2.1
2.2
2"
50.8 mm
3.1
3.2
3.3
For Standard
Models:
4.1
Adjust the tone
by moving the tabs on
the receiver as shown.
To equalize sound, move
the tabs to the same
setting on each receiver.
4.2
To emphasize lower,
or bass tones, move the
receiver tabs to the position
marked “ ”.
4.3
To emphasize higher,
or treble tones, move the
receiver tabs to the position
marked “ ”.
Boom
Headset Cord
Click
Stop
Turret
Ear Cushion
Tone
Control
Tabs
3.4
4.1
Back
Front
Polaris
™
Models
To use the Polaris headset
model, simply insert the
modular connector into
the headset receptacle of
a compatible telephone.
Polaris applies to most
headset ready telephones.
H191
Standard
Model
H101
Noise-
Canceling
Model
2.1
To adjust the headband,
lengthen or shorten the band
until it fits comfortably. The
clickstop feature keeps the
headband securely adjusted.
Position the headset receivers
so that the foam cushions sit
comfortably over the center of
your ears.
2.2
On models with only one
receiver, position the stabilizer
T-bar above your ear.
4.2
4.3
16845 Plantronics 11/7/02 10:33 AM Page 2
