www.planikafires.com
i0776#01
30.04.2014
2
Make sure that the bio fireplace is disconnected from the mains then put USB flash drive to USB port
on the side part of the product.
Connect the bio fireplace to the mains and wait min. 5 minutes. USB flash drive may be disconnected
and the product may be turned on with
button.
Hold ‘+’ for 8 seconds and ‘Customer’s menu’ will appear [p. 10 in User’s manual]. Press ‘+’ to go to
point 4 ‘Device IP’ and confirm by pressing ‘-‘.
Product’s IP needed for the operation via the configured appliance will be visible then. Correct IP
format is: 192.168.XXX.XXX .
It may happen that the displayed IP is incorrect. In such case follow the instructions below.
0.0.0.1
No communication with the module
at all
It is normal during the initialization of the
product. If it does not disappear after several
minutes after turning on the bio fireplace,
begin to format USB flash drive again.
0.0.0.2
No connection with the network
(wrong data / IP is busy / no network)
Follow the procedure of giving the network
parameters once more – install USB flash
drive again.
0.0.0.3
Text mode – jumper was not
downloaded
Follow the procedure of giving the network
parameters once more – install USB flash
drive again. Call SERVICE.
127.0.0.1 No connection with the network
(wrong data / IP is busy / no network)
Follow the procedure of giving the network
parameters once more – install USB flash
drive again.
WARNING! There is possibility to check the reason of configuration failure. To do this read the file
‘wifi.txt’.
Network parameters changed
The change of all the network parameters was successful
Error 0x01
Interfaces error (call service)
USB