Planeta HD3N-G-VZ, Руководство по эксплуатации и обслуживанию

Страница: 9 / 16

9
PLANETA PLANET PLANET
1861
Heben ohne Grenzen
Nut Torgue (Nm)
M10 26
M12 45
M16 110
M20 210
M24 365
M30 725
M36 1265
Special remarks for trolleys if they were
ordered for adjustable beam sizes:
– Each trolley and all its functions are tested in fully assembled version before
it leaves the company. The length of the hand chain is installed according the
requested lifting height (1 m less from lift) or according your special request
in purchase order. Your mentioned beam size will be recognized and adjusted
according your order. In most cases, the trolley is not adjustable. You may
have it ordered with adjustability, then we trust that the trolley will be for various
beam sizes in the range of possible static calculations. We will supply the trolley
unadjusted or unassembled.
– Please mind following remarks before you put the trolley into service:
The true dimension of the beam fl ange has to be measured and the width of the
trolley wheels has to be adjusted according this:
Runway-Beam fl ange width + ca. 2 mm = trolley wheel gauge in mm
There are distance discs and distance pipes on the carrying bolts of the trolley.
The required gauge of trolley can be reached by taking away or adding of these
distance elements. This mooves the side plates closer or wider to the beam fl ange.
It is important that the nuts will be tightened properly. This job has to be done
symetricaly so that the bottle load hook will be afterwards directly centered under
the beam fl ange. The distance discs which are not needed, shall be used outside!
– When the wheels have its correct position and the gauge is checked, put the big
disc and then the small distance discs outside on the bolt and fi x them with the nut.
– After this last check, the trolley can be rolled on the beam fl ange at the beam end.
If this is not possible because the beam is closed or too narrow, the trolley has to
be disassembled as discribed under item 5. Again: Please tighten the locking nuts
properly and check that they will not loosen by itself when the trolley drives on the
beam.