Routing setting as well as the fast NAT mode also cannot be used even it is
in the status of enable. After selected, please click “Apply” to make the
settings effect.
After configuration complete, please click “Apply”
button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press “Continue” for configure other
settings or “Apply” to restart WNRT-625G with new configuration. Please refer to section 4.2.7 for more
information about this screen.
5.6.1 Static
Routing
After you disable NAT mode, you can enable Static Routing to turn off NAT function of this router and let
this router forward packet by your routing policy.
Parameters
Description
Enable Static Routing
Check this box to enable Static Routing function, unselect this box if you
don’t want to turn off NAT function of this router.
Destination LAN IP
Type the Destination LAN IP address you use to access the Internet. Your
ISP or network administrator provides you with this information.
Subnet Mask
Type the subnet mask for your network. If you do not type a value here, your
ISP or network administrator provides you with this information.
Default Gateway
Type the gateway address of your network. Your ISP or network
administrator provides you with this information.
Hop Count
Input which hop count you want to apply to this configuration.
Interface
Select the interface which you would like to use (LAN / WAN).
Add
Click to add a configuration to the Current Static Routing Table at the bottom
of this page.
55
