32
Chassis Installation and Rack Mounting (VC-231G and
VC-231GF)
To install the Ethernet over VDSL2 Bridge in a 10-inch or
19-inch Converter Chassis with standard rack, follow the
instructions described below.
Step 1:
Place your VDSL2 Bridge on a hard flat surface, with
the front panel positioned towards your front side.
Step 2:
Carefully slide in the module until it is fully and firmly
fitted into the slot of the converter chassis.
Insert a VDSL2 Bridge into an available slot
Step 3:
Attach a rack-mount bracket to each side of the
Converter Chassis with supplied screws attached to the
package.
Step 4:
After the brackets are attached to the Converter
Chassis, use suitable screws to securely attach the
brackets to the rack.
Step 5:
Connect one end of the power cable to the
10-inch
or
19-inch
Converter Chassis.
Step 6:
Connect the power plug of the power cable to a
standard wall outlet, and then power on the
10-inch
or
19-inch
Converter Chassis. The PWR LED should be lit.
Note
Please refer to your User’s Manual for setting up
the device.