21
Refer to the following procedure to set up the VDSL2 Bridge to
IP DSLAM connection.
1.
[Remote End]
Set the remote IP DSLAM/VDSL2 switch to
CO mode with proper VDSL2 profile.
2.
[Local End]
Set the VDSL2 Bridge at the local end to CPE
mode from the DIP switch.
3. Power on the VDSL2 Bridge CPEs by connecting its power
source.
4. Power LED will illuminate.
5. Connect VDSL line from IP DSLAM/VDSL2 switch to RJ11
VDSL port
of the VDSL2 Bridge.
6.
VDSL LNK LED
will blink to illuminate.
7. Connect telephone to the RJ11
Phone port
of the VDSL2
Bridge.
8. Connect the VDSL2 Bridge Ethernet
LAN port
to other
network device via regular Cat.5 UTP cable.
When deciding where to put the converter and / or prolong the
operational life of the bridge, please also refer to the following
points:
It is accessible and cables can be connected easily.
Cabling is away from sources of electrical noise such as
radios, transmitters, motors, power lines and fluorescent
lighting fixtures.
Do not place objects on top of any unit or stack.
Water or moisture cannot enter the VDSL2 Bridge.
Air flowing around the unit and through the vents on the side
of the case is not restricted (We recommend that you provide
a minimum of 25mm clearance.).