Copyright
e
,
,
makes no representations or warranties, either expressed or implied, with respect to the contents
hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any
software described in this manual is sold or licensed "as is". Should the programs prove defective following
ET, its distributor, or its dealer) assumes the entire cost of all
ntal or consequential damages resulting from any defect in the
and to make changes from time to time
ederal Communication Commission Interference Statement
ent has been tested and found to comply with the limits for a Class B digital device, pursuant to
FCC Rules. These limits are designed to provide reasonable protection against harmful interference
, and can radiate radio frequency energy and, if not
d in accordance with the instructions, may cause harmful interference to radio
r, there is no guarantee that interference will not occur in a particular installation. If
use harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
1.
Reorient or relocate the receiving antenna.
2.
Increase the separation between the equipment and receiver.
3.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4.
Consult the dealer or an experienced radio technician for help.
FCC Caution
To assure continued compliance. (example use only shielded interface cables when connecting to computer or
peripheral devices). Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the Following two conditions: ( 1 )
This device may not cause harmful interference, and ( 2 ) this Device must accept any interference received,
including interference that may cause undesired operation.
Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In order to
avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna
shall not be less than 20 cm (8 inches) during normal operation.
Safety
This equipment is designed with the utmost care for the safety of those who install and use it. However,
special attention must be paid to the dangers of electric shock and static electricity when working with
electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all
times to ensure the safe use of the equipment
.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.
Copyright
reproduc
language
otherwise
PLANET
©
2010 by PLANET Technology Corp. All rights reserved. No part of this publication may be
d, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer
in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or
without the prior written permission of PLANET.
their purchase, the buyer (and not PLAN
necessary servicing, repair, and any incide
software. Further, PLANET reserves the right to revise this publication
in the contents hereof without obligation to notify any person of such revision or changes.
All brand and product names mentioned in this manual are trademarks and/or registered
trademarks of their respective holders.
F
This equipm
Part 15 of
in a residential installation. This equipment generates, uses
installed and use
communications. Howeve
this equipment does ca