10
Before you proceed with the installation, it is necessary that you have enough
information about WAP-6200.
1. Please connect right installation
Æ
“PoE” port of PoE inject to WAP-6200; “LAN”
port of PoE injector to LAN PC, wrong installation will cause the device damage
2. Using Category 3 or higher UTP or STP cable, connect the “LAN” port of PoE
Injector to a 10Mbps or 10/100Mbps Ethernet hub or switch, and connect the PC
on the same LAN for management.
3. Locate an optimum location and use the provided Mounting kit to tie the
WAP-6200 to a pole.
Note
1.
To avoid thunder strike, consider to install ELA-100, thunder arrester
toward the CPE AP and the PoE injector.
2.
For secured reason, while install the CPE AP, please be aware for the
electric wires around, and tighten the pole.
Without tighten the CPE AP, the pole and the installed site is with
electric wire around, there could be danger of being hurt by falling or
lethal injury.
4. Connect the power cord to the PoE Injector, and plug it into an AC outlet to power
on the WAP-6200.
Note
1. Strongly suggest using SFTP cable, for better protection of the data
wire. 25-meter SFTP cable also available by order, the part no is
WL-SFTP-25. Please contact with local dealer for more information
2. 2. Pleas also refer to Chapter 5 or Chapter 6 for more about LAN port
or WAN port selection. For the first time installation, it is suggested to
connect to LAN.
Note
1.
ONLY use the power adapter supplied with the WAP-6200.
Otherwise, the product may be damaged.
2.
Strongly suggest using SFTP cable whether the cable exposed
outdoor for waterproof and avoiding thunder stroke.