802.11n
Wireless
ADSL
2/2+
Router
ADN
‐
4102
46
3.6.1.2 IPv6 Static Route
Click
IPv6 Static Route
in the left pane and the page shown in the following figure appears. This page is
used to configure the routing information. You can add or delete IP routes.
The following table describes the parameters:
Fields
Description
Destination
Enter the IPv6 address of the destination device.
Prefix Length
Enter the prefix length of the IPV6 address.
Next Hop
Enter the IPv6 address of the next hop in the IPv6 route to the destination
address.
Interface
The interface for the specified route.
Add Route
Click it to add the new static route to the IPv6 Static Route Table.
Delete the Selected
Select a row in the IPv6 Static Route Table
and click it to delete the row.
3.6.1.3 RIP
RIP is an Internet protocol you can set up to share routing table information with other routing devices on your
LAN, at your ISP’s location, or on remote networks connected to your network via the ADSL line. Most small
home or office networks do not need to use RIP; they have only one router, such as the ADSL Router, and
one path to an ISP. In these cases, there is no need to share routes, because all Internet data from the
network is sent to the same ISP gateway. You may want to configure RIP if any of the following
circumstances apply to your network:
¾
Your home network setup includes an additional router or RIP-enabled PC (other than the ADSL
Router). The ADSL Router and the router will need to communicate via RIP to share their routing
tables.
¾
Your network connects via the ADSL line to a remote network, such as a corporate network. In order
