![background image](http://html.mh-extra.com/html/planet-networking-and-communication/ias-240/ias-240_user-manual_1563947020.webp)
Setup: Internet Access
If using the ISDN Access Server's built-in
hub with another hub, use the "Uplink"
10Base-T connector to connect to the other
hub's MDI-X port. Note that when the Uplink
port is in use, port 4 can NOT be used.
3. Connect ISDN Phone Line
Using a cable fitted with RJ45 plugs, connect the ISDN port
on the ISDN Access Server to the S/T interface on the NT-1
(Network Termination 1) ISDN terminator.
4. Connect Printer (IAS-2410 only)
Using a standard printer cable, connect the printer to the
printer port on the ISDN Access Server.
5. Power On and Check the LEDs
Connect the supplied power adapter to the ISDN Access
Server and press the ON/OFF switch on the back of the ISDN
Access Server. (In is ON.) When the ISDN Access Server is
powered On, all LEDs should blink, then, except for the PWR
LED, go off.
•
The LAN (LNK) LED will blink during normal operation
•
The ISDN and TEL LEDs will light when the relevant
port is in use.
•
If the ERR LED stays on, or both the ERR and LNK
LEDs blink, there is a hardware problem. For more in-
formation on the LEDs, refer to
Link/Error LEDs
on page
10.
Warning!
Only use the power adapter provided. Using
a different one may cause hardware damage.
Содержание IAS-240
Страница 5: ...iv ...