DS15 SET-UP
Bracket mounting instructions:
1. Mount the DS15 to a table stand, floor stand, or wall using your VESA hardware.
A standard 75mm VESA mounting pattern is located on the back of the unit.
Attach the VESA mounting bracket (not included) with the four (4) screws
provided. Detailed mechanical drawings, including mounting-hole patterns,
may be found at www.planar.com/support.
2. If necessary, clean the front surface of the display using compressed air
or wipe with a clean, dry, soft cloth.
3. Tightly secure all mounting hardware.
Setup for networked and non-networked DS15 Operation
1. Connect the cord attached to the power adapter to the
power outlet located in the lower left corner on the
back of the unit as shown.
Fig. A
2. Attach the power cord to the power adapter, and then
plug the cord into an active wall outlet, located
approximately 5 feet (1.5 meters) from the unit.
Fig. B
3. If operating in non-networked mode, see 3a.
If using networked mode use 3b.
3a. Turn unit on. Switch is located on the top back of the
DS15.
Fig. C
3b. Open door located at the bottom of the back of the unit
(secured with one Philips screw) and attach an Ethernet
CAT5 cable (not provided).
Fig. D.
The unit will receive an
IP address from a DHCP server.The DS15 is now ready to
receive the playback schedule and content over the network.
4. The DS15 will automatically power up. Following screen
prompts, use your finger to set the regional time zone
and local time.
5. Close the window by tapping the “APPLY” button. The unit
will automatically re-boot. This will take approximately
one minute. A default content screen will then appear.
Fig. E
The DS15 is now operational and able to accept
a Content CD packaged by the Planar Content Manager.
DS15 INTEGRATED MARKETING SOLUTION
USER'S MANUAL
The DS15 is designed to operate in either a standalone or networked mode. Follow
the instructions in this User’s Manual for installation; creating, scheduling and
deploying content; and administering the DS15.
These are the basic steps to follow:
1. Install the DS15 Integrated Marketing Solution at the location
where it will be used.
2. Install the enclosed Content Manager CD on your PC.
3. Develop content or get it from the advertising agency in the
appropriate format.
4. Use Content Manager to load and schedule content.
If you are using the DS15 in standalone mode go to 5.
If you are using the DS15 in networked mode go to 6.
5. Burn the content and scheduling information to a CD and load in unit.
You are finished.
6. Export the content to a file and use Administrator to deploy content
over a network. You are finished.
IF YOU ARE RESPONSIBLE FOR: . . . . . . . . . . . . . . . . . . . . . . . . . . . SEE PAGE
INSTALLATION AND SET-UP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
INSTALLATION AND USE OF CONTENT MANGER. . . . . . . . . . . . . . . . . . 4-5
DEPLOYING CONTENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
ADMINISTERING THE DS15 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Fig. B
3
2
Fig. C
Fig. A
Fig. D
Fig. E
