24
Dome Q2 Display
QUICK LINKS
GETTING STARTED
INSTALLING THE DISPLAY
OPERATING THE DISPLAY
APPENDIXES
Display indicates “Controls Locked”
Press the Menu and right arrow buttons simultaneously for about 3 seconds,
until the message “Controls Unlocked” appears.
Display image is incorrect
Press the Auto button to adjust your display image automatically to the ideal setting.
If the results are unsatisfactory, adjust the image position using the H-position and
the V-position on the onscreen display.
Check the display settings in the Control Panel (Control Panel > Display > Settings) to
see if the frequency or the resolution were changed. If so, readjust the video card to
the recommended resolution.
Press the Auto button to adjust your display image automatically to the ideal setting.
If the results are unsatisfactory, decrease the vertical bars or stripes using the Clock menu in
the onscreen display.
Press the Auto button to adjust your display settings automatically to the ideal setting.
If the results are unsatisfactory, decrease the horizontal bars using the Phase menu in
the onscreen display.
Check the display settings in the Control Panel (Control Panel > Display > Settings) to adjust to
the recommended resolution and to adjust your display image to the ideal setting.
Check that the signal cable is properly connected. Use a screwdriver to secure
the connection.
Make sure the video card is properly installed.
Check that the screen is set to interface mode. If so, change it to the resolution recommended,
1600 x 1200.
Make sure the power voltage is high enough. It must be higher than AC100 – 240 V 50/6 Hz.
Problem
Possible Solution