Plamen Termo Glas, Инструкция по установке и эксплуатации

Страница: 20 / 60

The cooker should be regularly cleaned and inspected by a chimney sweeper or some other
qualified person. Clean the cooker with maximum caution and only when completely cooled
down. Remove and clean the top plate and flue pipe. Brush off the soot built up on the internal
walls and pull the oven bottom plate out to discharge soot and ash. Clean and inspect the cooker
every time after a prolonged suspension of operation.
To control the flame, add fuel as necessary and control the air supply by means of the air control.
Minimum output (low flame) is achieved by setting the air supply to minimum. In case of
overload (flame too high), set the air control to minimum and wait for the flame to abate
gradually.
When using the oven, particularly for bread and other leavened dough baking, proceed, in order
to avoid
burning on top , as follows:
- Flue damper rod shall be pushed inwards.
- Pre-heat the oven to 170-190 °C
- Add only one smaller log at a time to keep the fire at a moderate level for even baking on
all sides. It is recommendable to turn the baking pan once during the baking.
- Fast boiling and better cook plate heating is achieved with the flue damper in open
position, i.e. with the knob being pulled out.
Always bear in mind that the cooker parts, and particularly the top plate, INOX knobs, firebox
door, handrail and damper rod, are hot and that only adults may operate the cooker. FOR THAT
PURPOSE USE A PROTECTIVE GLOVE!
The cooker must not be subject to any unauthorised repairs and/or modifications. Such
operations may be performed only by qualified persons and only original spare parts should be
used.
During normal operation, particularly if the cooker is fired with wet wood, soot and tar build up,
posing a risk of fire in the chimney if it is not regularly inspected and cleaned. If the chimney
catches fire, proceed as follows:
- Do not use water to extinguish the fire
- Close all air inlets to the cooker and chimney
- After the fire has gone out, call a chimney sweeper to inspect the chimney
- Call an authorised maintenance workshop, i.e. the manufacturer to inspect the
cooker
The installed power in the heating system should be 7,5 kW.
It's used for cleaning enamel and painted parts using soap and water, non-abrasive or
chemically non-aggressive detergents.
20