Plamen Dora 10 N, Технические инструкции, Страница: 19 / 60

19
The stovepipe must not protrude into the cross section of the chimney.
Good heating performance will be achieved if the stove is connected to a properly designed and
maintained chimney, ensuring good draught i.e. negative pressure of 10-20 Pa.
Only one stove (one unit) shall be connected to the chimney.
The stove shall be installed in full compliance with applicable European, national as well as local
regulations.
INSTRUCTIONS FOR USE
Fuel
The stoves have been designed to burn wood and wood briquettes.
Use only well-seasoned dry wood to reduce the likelihood of greasy soot (creosote) build-up, which
may cause clogging of the chimney.
Do not burn household waste, especially not any plastic material. Many waste materials contain
substances that are harmful to the stove, the chimney and the environment.
Also, never burn chipboard waste, because chipboard contains glues which may cause overheating
of the stove.
Recommended single fuel loads:
*Optimum log size: diameter 30 cm, length 25 cm
Make sure not to exceed recommended fuel loads. Excessive fuel loads may
cause overheating and damages, which are excluded from the Warranty.
Prior to reloading, make sure to riddle the riddling grate to let sufficient air into the firebox which is
essential for good combustion.
First firing
Start the fire with a small amount of crumpled newspaper and well seasoned dry kindling to achieve a
moderate, evenly burning fire.
Read the instructions concerning the air supply controls on your stove.
Some parts of the stove are painted with a heat resistant paint. With the first firing, this paint gradually
sets and some fumes of a characteristic odour may be given off in the process.
Therefore ventilate the room during this phase.
Firing and regular operation
Crumple a small amount of newspaper and place it in the fire box. Over the paper place dry kindling
wood and then 2-3 small logs. Make sure that primary and secondary air supply
controls are fully open and let the fire blaze-up.
When firing the stoves, it is recommendable to leave the firebox door ajar for 2-4 min in order to avoid
steaming / staining of the glass.
Never leave the stove unattended until a bright active fire has developed. During the normal
operation, the firebox and the ash tray doors must be closed.
If you have a damper installed in your fluepipe, it should be kept fully open at the beginning.
The desired output is set by means of the primary air flow controls.
The stoves are structurally designed in the manner that the glass on the firebox door is always kept
clean. The glass may become stained with soot only in case of poor combustion, which might be due
to the following causes: chimney of inadequate design or in poor maintenance
Logs*
Wood briquettes
Brown coal briquettes 7”
max. 2 kg 2,5 - 3 kg
max. 2 kg 2,5 - 3 kg
max. 1,6 kg
2 - 2,5 kg
Dora 8 N Dora 10 N