Plamen Authentic 35, Техническое руководство

Страница: 34 / 72

Chimney
Existing flue
- The chimney must comply with the Current Building Regulations. If in doubt, consult your
Dealer or local Building Inspector.
- The flue must be in good condition and must provide sufficient draught (refer to technical
details p. 30 ).
- The flue must be suitable for the installation of solid fuel
burning appliances and comply with the Current Building
Regulations.
-
The flue must be clean. It should be swept to remove soot and
dislodge tar deposits.
- The flue must be well insulated. If the flue inner wall surfaces
are cold, a good thermal draw is impossible causing
condensation problems (tar formation etc) to occur.
- The flue must not be shared with other appliances.
-
The chimney must be at least 4.5 m (15 ft high).
- In case of a flat roof or when the roof gradient is lower than 15°, the stack must be 1,2 m (4
feet) high at least.
- If the chimney has any down draught tendency, due to its position in relation to nearby
obstacles, then an anti-down draught cowl must be installed on the chimney or the chimney
height must be increased.
- If the decompression in the chimney is excessive, a draught stabiliser must
be installed.
Chimney to be built – New flue
- The chimney must comply with the Current Building Regulations. If in doubt, consult your
Dealer or local Building Inspector.
- The appliance must not support the weight of the flue.
- Consult a chimney specialist for advice on suitable flue systems for solid fuel appliances.
- It must be distant from any combustible material (walls, cross members)
- It must permit an easy sweeping
.
Page 34/72
Authentic 35