Pkm UBH 5000H2, Инструкция по эксплуатации

Страница: 24 / 70

24
8. If the exhaust duct passes through cool areas (e.g. an attic), a temperature
gradient may occur in the different parts of the exhaust duct so condensate will
be generated. Proper insulation of the corresponding parts of the exhaust duct
will then be needed. Equip such an exhaust duct with a condensate trap if need
be.
Installation steps
WARNING! Failure to install the screws or fixing device in
accordance with these instructions may result in electrical hazards.
WARNING! Do not damage the wiring in the wall while drilling

Depending on the model the hood is equipped with one (top) or two (top,
back) air outlets.

The extractor hood is normally preset for using the top outlet as well as for
extraction mode.

The idle outlet is covered by a plastic cap. You can remove this cap by turning it
anticlockwise. Use the cap to cover the idle outlet.

If your appliance is equipped with a carbon filter, remove the carbon filter
before you run the appliance in the extraction mode. The carbon filter should
be used in the recirculating mode only.
NOTICE!
If the hood is installed without an exhaust duct it must be operated in
recirculation mode only. The air outlets on the upper front side must be open;
otherwise the capacity of the hood is reduced. The appliance is preset for
recirculation mode. Any complaints caused by faulty-set operation mode cannot be
accepted.
Small plastic plate inside the hood; left side of the motor.
Extraction mode Recirculation mode