~ 55 ~
3. Installation
All dimensions in these chapters are given in
millimetres.
The minimum distances required for proper ventilation can be found in chapter
3.2.2
V
ENTILATION
REQUIREMENTS
.
3.1 Unpacking and positioning
WARNING!
While unpacking, the packaging materials (polythene
bags, polystyrene pieces, etc.) should be kept away from children and
pets. CHOKING HAZARD! RISK OF INJURY!
1.
This appliance is not intended for built-in installation.
2.
Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
3.
Remove all packaging materials.
4.
The accessories of your appliance can be protected from damage due to
transportation (adhesive tapes etc.). Remove such tapes very carefully. Remove
remains of such tapes with a damp cloth using lukewarm water and a mild
detergent (see also chapter
CLEANING AND MAINTENANCE
). Never remove any
components of the back of the appliance!
5.
Install the appliance in a suitable position with an adequate distance from sources
of heat and cold.
6.
If installation near a heat source is unavoidable, use a suitable insulation plate or
keep the following
minimum distances
to the heat source:
to another refrigerators:
min. 20 mm
to electric cookers:
min. 30 mm
to radiators or ovens:
min. 300 mm
7.
Install the appliance in a dry and well-ventilated place.
8.
Protect the appliance from direct sunlight.
9.
The door(s) must open completely and without hindrance.
10.
Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
11.
Check that the appliance and the power cord are not damaged.
12.
Connect the appliance to the mains properly.
13.
The rating plate is inside the appliance or at the back.
