52
2. Installation
2.1 Unpacking and positioning
1.
Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2.
Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3.
Check that the appliance and the power cord are not visible damaged.
4.
Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
5.
Install the appliance on a
level, dry and solid floor
. Check the correct
installation with a bubble level.
6.
Remove the complete packaging material ( inside and outside the appliance)
before initial operation.
7.
The nameplate is situated inside the appliance or at the back.
2.2 Installation of the hob
1.
Make an installation-opening with the dimensions given on the following
drawing (s.
fig. 1
, below).
2.
Fix the supplied sealing tape on the corresponding place of the hob.
3.
Check the seal for perfect fit and overall cover. Insert the electric hob in the
opening and align it correctly.
4.
Using a standard screwdriver, tighten the tension clamps evenly starting at the
centre and moving diagonal, until the built-in rim is tight on the worktop.
5.
The hob must be vented properly. Air inlet and air outlet must not be blocked.
Содержание EH8-2KB IXS
Страница 13: ...13 MAßE DES BACKOFENS ABB 1 MAßE DER EINBAUÖFFNUNG ABB 2 ...
Страница 16: ...16 2 5 Elektrischer Anschluss Kochfeld KLEMMLEISTE A ROT B WEIß ...
Страница 55: ...55 DIMENSIONS OF THE INSTALLATION OPENING FIG 2 All dimensions in fig 2 are given in millimetres Figure 3 ...
Страница 58: ...58 2 5 Electrical connection of the hob TERMINAL BLOCK A RED B WHITE ...