15
hood edge rests
inside side clips
facing upward
right angled
rear clip surface
captures outer
rim of grill bowl
FIG. 3
FIG. 4
18.5” MASTERBUILT PRO:
Set the hood onto your Pizza Kit so that the back edge of the grill hood channel seats
into the clips opening upward (as shown in FIG.3) and the hood rim rests comfortably
on the front support tabs. Then loosen the rear clip and set it so the right angled
surface captures the rim of the grill bowl and re-tighten (as shown in FIG. 4). Check to
confirm your hood is stable before continuing, if not, re-adjust placement until stable.
18.5” WEBER:
Set the hood onto your Pizza Kit so that the back edge of the grill hood channel seats into the opening
of the upward facing side clips (as shown in FIG. 5). Make sure the hood rim rests comfortably over the
front support tabs. Check to confirm your hood is stable before continuing, if not, re-adjust placement
until stable.
hood edge rests
inside opening
of upward fac-
ing side clips
FIG. 5
back clip
back clip
back clip
SIDE VIEW
SIDE VIEW
SIDE VIEW
