8
Rear Panel
11
10
9
8
7
6
5
4
3
2
1
No.
Name
Description
1
DC 12V
Connect this port to a 12 V 1 A power adapter.
2
Reset
Use this button to reset device.
When NEX-E500 is powered on, use a pointed stylus to
hold down this button for five or more seconds, and then
release it, it will reboot and restore to its factory defaults.
3
LAN (PoE)
10/100/1000 Base-T port, connect this port to a gigabit
Ethernet switch for IP stream output, device control and
management.
Default Protocol
Default IP Mode
Auto IP
IP Address
169.254.x.x
Subnet mask
255.255.0.0
4
Audio In
Connect this 3.5 mm stereo tip-ring-sleeve port to an
audio source such as a computer for unbalanced stereo
audio signal input.
Note:
When this audio port is connected to an audio source,
both encoder and decoder will output the audio signal from the
audio source instead of that from the HDMI video source. If this
audio port is connected via an audio cable but no audio signals
are input, you can get picture but no sound. The situations above
do not apply to the HDMI loop-through port in encoder, which can
still output the AV signals from the video source.
5
Audio Out
Connect this 3.5 mm stereo tip-ring-sleeve port to an
audio receiver such as a speaker or amplifier for
unbalanced, stereo audio signal output.
6
RS232
Use this port to perform bi-directional serial
communication and device debug functions.
When the front panel "MODE" switch is moved to
the "NORMAL" position, connect this port to a
RS232 device such as a computer to bi-directionally
communicate with a RS232 device at the IP control
box side.
When the front panel "MODE" switch is toggled to
