10
No.
Name
Description
4
DIP
This DIP switch consists of four manual switches, which
are used to route audio, video together with IR, and
USB signals between NEX-E500 and NEX-D500 based
on their positions. By default, each individual switch is in
the up position. For more information, see "Using DIP
Switch to Perform Routing".
Note:
For the DIP switches in both encoder and decoder,
changes to them take effect immediately without
rebooting the system.
5
USB Hub
Connect the two USB type A ports to a USB keyboard
and mouse. The connections are USB 2.0 compatible,
pro5 VDC at up to 500 mA to connected USB
peripherals.
Rear Panel
8
7
6
5
4
3
2
1
No.
Name
Description
1
DC 12V
Connect this port to a 12 V 1 A power adapter.
2
Reset
Use this button to reset device or quickly remove link
relationship between decoder and encoder.
Device reset:
When NEX-D500 is powered on, use
a pointed stylus to hold down the Reset button for
five or more seconds, and then release it, it will
reboot and restore to its factory defaults. This
function will disconnect decoder from encoder.
Remove decoder and encoder link relationship
quickly: When encoder is routed to decoder using
PC configurator, PF-IP Touch or IP control box, hold
down the Reset button for less than five seconds,
and then release it, it reverts to the link relationship
between encoder and decoder set via the link DIP
switch. This function applies to decoder only.
3
LAN (POE)
10/100/1000 Base-T port, connect this port to a gigabit
Ethernet switch for IP stream input, device control and
management.
