manualshive.com logo in svg

Pixapro Zione, Инструкция по эксплуатации, Страница: 4 / 4

Поделиться
Скачать
Pixapro Zione Скачать руководство пользователя страница 4

Unit 5 Sterling Park, Pedmore Road, Brierley Hill, 

West Midlands DY5 1TB

Tel: +44 (0)121 552 3113

Email: [email protected]

Step 2. 

Step 11. 

Step 4. 

Now that all of the shelves have been screwed in, please 
check to ensure there is approximately a 1-2mm gap be-
tween each of the shelves, and make sure the rubber stud 
(circled in red) is touching or close to the outer frame. To 
prevent any misalignment issues.

Step 2. 

Step 13.

Step 12. 

Final Step 

Instruction Manual

ZIONE 2in1 Convertible Desk and Shelf

Check that each of the shelves are even when the ZIONE is 
set to the horizontal desk position as shown.

Loosen the Tapping screws that have already been insert-
ed slightly, and use the screws shown below in the round 
hole next to where the tapping screws went, to make any 
height-adjustments you need to the shelves.

Last but not least, attach the remaining crossbar to the hole 
circled in red, on both sides of the Zione 2in1 Desk and 
Shelf.

Содержание Zione

Страница 1: ...and washers from the end of the bolts shown below and insert them into the holes that you have just drilled NOTE These bolts are designed for use with Solid brick or concrete walls For use on Hollow or Plaster board walls please seek advice at your local hardware retailer GROUND LEVEL 555mm 680mm 580mm Step 2 Step 1 Step 2 4x 2x 10x 4x 12x 10x 2x 22x Parts List Main Frames 2x Crossbars 2x Gas Fill...

Страница 2: ... the bold earlier back onto the bolt and tighten them using a wrench or spanner Get one of the crossbars and remove the screws from the sides Insert the crossbar between the two main frames and screw either end into the hole shown circled in red the photos below Do the same for the opposite side Once attached move the frame up into the vertical position as shown below and insert one of the followi...

Страница 3: ...th a nut then tighten the nut until the gas tube is fully secured Do the same for the opposite side Once the gas tubes have been installed pull the frame back down to the horizontal position and place the shelves on top of the frame then make sure each panel is aligned with the frame as shown below before screwing them in Once the shelf panels are properly aligned use the self tap ping screws show...

Страница 4: ...rame To prevent any misalignment issues Step 2 Step 13 Step 12 Final Step Instruction Manual ZIONE 2in1Convertible Desk and Shelf Check that each of the shelves are even when the ZIONE is set to the horizontal desk position as shown Loosen the Tapping screws that have already been insert ed slightly and use the screws shown below in the round hole next to where the tapping screws went to make any ...

Отзывы:

Нет отзывов