Step 2.
Step 3.
Step 4.
Now place the main parts of the frame over the bolts that
you have placed in the holes you have drilled as shown
below. The holes are long to allow you to compensate any
misalignments.
Step 2.
Step 5.
Step 4.
Step 6.
Instruction Manual
ZIONE 2in1 Convertible Desk and Shelf
Place the washer and the nut that you removed from the
bold earlier back onto the bolt, and tighten them using a
wrench or spanner
Get one of the crossbars and remove the screws from the
sides. Insert the crossbar between the two main frames,
and screw either end into the hole shown circled in red the
photos below. (Do the same for the opposite side).
Once attached, move the frame up into the vertical position
as shown below, and insert one of the following bolts to
the outer side of each frame as shown below, and use one
of the nuts to attach it to the frame. (Do the same for the
opposite side).