As a Wireless Outdoor Flash Trigger
Turn off the camera and mount the transmitter
on camera hotshoe. Then, power on the flash
trigger and the camera.
Short press the < MENU > button to enter the C.
Fn Menu to set channel and group. Short press
<MODE.LOCK> button to set flash trigger mode,
turn the select dial to set flash trigger level. (refers
to the contents of “Setting the Flash Trigger”)
Power on the outdoor flash and press the wireless setting button and the wireless
icon will be displayed on the LCD panel. Long press the <GR/CH> button to set the
same channel to the flash trigger, and short press the < GR/CH> button to set the
same group to the flash trigger (Note: please refer to the relevant instruction manual
when setting the outdoor flashes of other models).
Press the camera shutter to trigger and the status lamp of the flash trigger turns red
synchronously.
1.
3.
4.
2.
Take CITI600Pro as an example:
Battery Installation
Slide the battery compartment lid of the flash
trigger and insert two AA batteries (optional)
separately.
Battery Level Indication
Check the battery level indication on the LCD panel
to see the remaining battery level during the usage.
As a Wireless Camera Flash Trigger
Turn off the camera and mount the transmitter
on camera hotshoe. Then, power on the flash
trigger and the camera.
Short press the < MENU > Button to enter the
C.Fn. menu, turn the Select Dial to < wireless
function > and press the < SET > Button to set
groups, mode and other parameters.
The battery indication only refers to AA alkaline batteries. As the voltage of Ni-MH battery tends to
be low, please do not refer to this chart.
Battery Level Indication
3 grids
2 grids
1 grid
Blank grid
Blinking
Power Status
Full
Middle
Low
Low power , please replace it.
2.5V The battery level is going to be used out
immediately (please replace new batteries, as low
power leads to no flash or flash missing in case of
long distance).
As a Wireless Studio Flash Trigger
Turn on the camera flash, press the wireless setting button and the wireless icon
and <RX> icon will be displayed on the LCD panel. Short press the < MENU >
Button to enter the C.Fn. menu, press the <CH> button to set the same channel to
the flash trigger, and press the <Gr> button to set the same group to the flash
trigger. (Note: please refer to the relevant instruction manual when setting the
camera flashes of other models)
Press the camera shutter to trigger and the status lamp of the flash trigger turns
red synchronously.
Turn off the camera and mount the transmitter on
camera hotshoe. Then, power on the flash trigger
and the camera.
1.
3.
4.
1.
2.
Take V1 series camera flash as an example:
Take STORM III as an example:
27
28
A
M
21
Содержание ST-IV+ L
Страница 14: ...47 48...