Pixapro ST-IV+ L, Инструкция по эксплуатации, Страница: 12 / 16

Restore Factory Settings
Synchronously press the two function buttons in the middle for 2 seconds, the “RESET”
is displayed on the LCD panel with CANCEL and OK options, choose OK and short press
SET button, it will automatically return to the main interface after the restore factory
settings are finished
.
Firmware Upgrade
This flash trigger supports firmware upgrade through the Type-C USB port. Update
information will be released on our official website.
Attentions
The Reason & Solution of Not Triggering in
PiXAPRO 2.4G Wireless
Unable to trigger flash or camera shutter. Make sure batteries are installed correctly
and Power Switch is turned on.
Check if the transmitter and the receiver are set to the same channel, if the hotshoe
mount or connection cable is well connected, or if the flash triggers are set to the
correct mode.
Camera shoots but does not focus. Check if the focus mode of the camera or lens is
set to MF. If so, set it to AF.
Signal disturbance or shooting interference. Change a different channel on the device.
Disturbed by the 2.4G signal in outer environment (e.g. wireless base station,
2.4G wifi router, Bluetooth, etc.)
→ To adjust the channel CH setting on the flash trigger (add 10+ channels) and
use the channel which is not disturbed. Or turn off the other 2.4G equipment in
working.
Please make sure that whether the flash has finished its recycle or caught up
with the continuous shooting speed or not(the flash ready indicator is lighten)
and the flash is not under the state of over-heat protection or other abnormal
situation.
ZOOM setting
TCM function
Firmware upgrade
Memory function
Display
Wireless Flash
Transmission range (approx.)
Built-in wireless
Modulation mode
Channel
Wireless ID
Group
Other
Adjust the ZOOM value by the transmitter from
AUTO or24 to 200
Transform the TTL shooting value into the output
value in the M mode
Upgrade through the Type-C USB port
Settings will be stored 2 seconds after last
operation and recover after a restart
Large LCD panel, backlighting ON or OFF
0-100m
2.4GHz
MSK
32
01-99
16
95mm*62mm*49mm
93g
2413.0MHz-2464.5MHz
2402.00MHz -2480.00MHz
5dbm
Dimension
Net Weight
2.4G Wireless Frequency
Range
Bluetooth Transmission
Frequency
Max. Transmitting Power
1.
1.
2.
2.
3.
Note: USB connection line is not included in this product. As the USB port is a
Type-C USB socket, please use Type-C USB connection line.
As the firmware upgrade needs the support of PiXAPRO G3 software, please
download and install the "PiXAPRO G3 firmware upgrade software" before
upgrading. Then, choose the related firmware file.
43 44