3
Parts & How To Use
6. Power Switch
7. Power Input Port
8. Reflector
9. Yoke Bracket
10. Umbrella Locking Screw
11. Stand Locking Screw
12. Modifier Release
13. Angle Adjustment Screw
14. Handle
15. LED Chip
1. Colour Temperature Dial
2. Parameter Store/Read Button
3. USB Receiver Port
4. LCD Screen
5. Power Dial
1. Power Input
Connect the power adapter, to the Power Input port (7), located at the back of your LED200B MKIII. Please
pay attention to orientation of the bayonet on the power connector. You should hear a “click” which indicates
that your power adapter is securely connected to your LED200B MKIII unit. Once connected, plug your power
adapter into the mains power socket, and switch on the power switch (6). LCD display (4) should then light-up to
indicate that the unit is ready for use.
2. Power/Colour Tempterature Adjustment
To control the Power output, rotate power dial (5) clockwise, the power will increase in increments of10%. if you
rotate the power dial in an anti-clockwise direction, power decrease in 10% increments for quick adjustments.
For more precise power adjustments, press power dial (5) in once, and the percentage on the display should
blink. Rotate the dial in a clockwise direction, and the power increase by increments of 1% for every click; Rotate
the dial in an anti-clockwise direction, and the power decrease by increments of 1% for every click;
The Power range goes from 0-100%. 100% represents full power status, and 0% represents off power status.
To control the Colour-Temperature, rotate the Colour-Temperature dial (1) cloackwise, and the Colour-Temper-
tature will increase up to 5600K (Daylight Balanced. If you rotate the colour-temperature dial anti-clockwise, it
decrease down to 3200K (Tungsten Balanced).
How To Use
