4
PIVOT CORPORATION
87-3, Shimookada Okada, Matsumoto-shi, Nagano, 390-0313 JAPAN
+
POWER
Troubleshooting
Because after changing displays, if the car’s engine is turned off within 3 seconds, the new setting will
not be stored, make sure to wait at least 3 seconds before turning the engine off.
Please reconfirm whether wiring and connections
are correct or not.
Please reconfirm the Fitting List.
Upon star ting up, the unit will not star t in the
newly changed display.
Poor connection of
Gauge cable
,
6-pin Connector
or
OBD Connector
wires.
Trouble
Possible Causes
Possible Solutions
Does not work with Engine start.
Illumination brightness settings
The unit has been installed into an incompatible
car model.
Before the opening demo starts the needle briefly
moves.
This is due to a special characteristic of the meter and is not a malfunction.
The displayed values are different from the standard
meter.
Due to the ECU information received, the displayed values on this product may differ from those of
standard or other meters.
Adjustment in case of anxious about reflected illumination of door mirror
or something
[
c-1
= White,
c-2
= Blue ]
1
2
3
5
6
Press
the switch
for 6 seconds
Holding downs the switch
in operation
Display a peak value after
3 seconds and the current
brightness after 6 seconds
(Initial value)
Release the switch
after displayed
the current setting
Release
the switch
after setting is done
Setting Completed
Back to normal display with
no operation for 5 seconds
Illumination color settings
Each pressing will change the color
1
2
3
4
5
Display the current
illumination color setting
Press the
switch to change
the color
(Initial value)
Release the switch
after displayed
the current setting
Release the switch
after setting is done
Setting Completed
Back to normal display with
no operation for 5 seconds
After the meter off,
Engine start during
pressing the switch
Switching The Display
Switching The Digital Display
Display and Reset the Peak Value
Water Temp
Voltage
Motor RPM
(Lighting)
(Lighting)
(Lighting)
(Blinking)
(Blinking)
(Blinking)
Real-time Display
Peak Value Display
Reset the Peak Value
Only the peak value on display will be reset. This will return to the Real-time Display
for the currently displayed mode.
Press
Switch
Press
Switch
for
3
Seconds
for
3
Seconds
With no operation
5
Seconds
Press switch to change
the multi-digital display
in operation
(decimal point
is lightning)
Water Temperature Reading the Display
- 35–-1 °C
0–99 °C
100–150 °C
Motor RPM Reading the Display (display unit : 100rpm)
0–9900rpm
over 10000rpm
READY Mode
• Peak readings are reset when the power is turned OFF.
• For RPM and Water Temperature the high will be shown and for Voltage the low will be
displayed.
• For Motor RPM the high Peak Value will be shown on the Digital Display.
4
Press the switch
to change the brightness
Each pressing will change the brightness
(High)
(Mid)
(Low)
Numerical Value Only.
The first place on the
left shows “
-
” (minus).
The third place from the
left shows “
c
” (Celsius).
• Our products have already been recognized as our Industrial Property or are in the process of receiving Industrial Property status.
• We plan in the near future to take all possible legal measures to protect against unfair competition from look-alike products using similar designs, regulating characteristics,
circuitry and circuitry layout.
• We strictly prohibit the unlicensed use of the PIVOT trademark and the unauthorized use of PIVOT User’s Manual.
(Note)
