Piusi PW Mobile, Инструкция по установке и эксплуатации

Страница: 49 / 64

49
/124 49
/64
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
translated from italian
PW Mobile
12 CONFIGURATION
FOREWORD Access the contents of the case by unscrewing the 4 screws that close the
cover. To proceed with the configuration of the PW Mobile 4G module,
follow the following steps:
1 Loos the three screws
- DO NOT REMOVE THEM
COMPLETELY -
and lift the metal sheet
1
2
2 Insert the SIM in the PW Mobile, us-
ing trolley no. 1 slot
The data traffic generated by the system
varies depending on the configuration of
the system and its use. It is advisable to pur-
chase a data plan that covers a traffic of at
least 50MB / month
3 Connect the PW Mobile 4G to a PC using a LAN cable
1
2
ATTENTION This procedure is necessary only during the first configuration stage
PW Mobile Router has one Ethernet port with two
LED indicators. The yellow one is link indicator and
the green one is speed indicator. For details about
status, see the table below.
ETHERNET
PORT
INDICATORS STATUS DESCRIPTION
Link indicator On, solid Connection is established
On, blinking Data is being transferred
Off Connection is not estab-
lished
Speed indicator On, solid 100 Mbps mode
Off 10 Mbps mode
4 Once the wiring is complete, download the software
‘PW Mobile-CONFIGURATOR’ from:
https://wswebssm.piusi.com/pwmobileconfigurator/
and proceed the configuration
NOTE For the tool to connect, the network card to which the PW Mobile is con-
nected must be configured in DHCP.