Piusi PW Mobile, Инструкция по установке и эксплуатации

Страница: 42 / 64

M0483
42
/64
Installation and use
11 INSTALLATION
FOREWORD
The PW Mobile can be installed on the wall or mounted directly on the stations.
WALL MOUNTING Pay attention to the length of the cables. Follow the instructions described
in chapter 11.1.
INSTALLATION ON
CUBE OR SELF SERVICE:
It is necessary to drill the body of the station. Follow the instructions listed
ATTENTION The installation operations are performed with door open and power con-
tacts accessible. All these operations must be performed with the appli-
ance isolated from the power mains to avoid any risk of electric shocks!
All the following operations must be performed by skilled electro-techni-
cal or electronic experts qualified.
The use of accessories that are unsuitable and were not provided with the
system is strictly prohibited. Piusi S.p.A. accepts no responsibility for dam-
age to persons, property or the environment caused by failure to comply
with this requirement.
INSTALL THE APPLIANCE WITH CABLE GLANDS FACING DOWN AND
PROVIDE A PROTECTIVE COVER.
11.1 PW MOBILE INSTALLATION FOR MC BOX 2.0 AND OCIO 2.0
Wall fixing is necessary for the PW Mobile, for use with MC BOX 2.0 e OCIO 2.0
For a wall mounting, run no. 4 holes diameter 6 mm for fisher M4.
For fixing on walls other than bricks, drill appropriate holes according to the
measures shown in the diagram.
1
Use the through holes on the box to install the PW Mobile case directly to a wall
ATTENTION THE SCREWS FOR THE WALL MOUNTING OF THE PW MOBILE ARE NOT
SUPPLIED. The installer will have to select the M4 screws suitable for the in-
stallation destination.
2
Proceed with wiring as described in chapter 11.4
219
140
SCREWS NOT SUPPLIED