Pittsburgh 60344-47, Руководство пользователя и инструкции по безопасности

Страница: 6 / 12

Page 6 For technical questions, please call 1-800-444-3353. Items 60344-47
SAFET
y
Op
ERA
TION
INS
pE
c
TION
INST
ALLA
TION
Operation Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION yy section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy REVENT SERIOUS INJUR REVENT SERIOUS INJUR : Operation of a vertical hoist involves more than depressing
the Up or DOWN control. The use of vertical . The use of . The use of hoists is subject to certain hazards that cannot be
met by mechanical means, but only by the exercise of intelligence, care, common sense, and
experience in anticipating the motions that will occur as a result of operating the controls.
Before Operating Hoist
1. Familiarize yourself with all operating controls
of the hoist and with the operation(s) to be
performed. Instructions include, the warnings
on the hoist, and the safety and operating
instructions portion of this manual.
2.
WARNING! TO pREVENT SERIOUS INJURy REVENT SERIOUS INJUR REVENT SERIOUS INJUR
FROM HOIST FAILURE:
Do not use damaged equipment.
If adjustments or repairs are necessary, IfIf
or any defects are known, have the
problem corrected before further use.
3. Do not operate a hoist with an out-of-order sign.
4. Only a qualified technician should
perform maintenance to the hoist.
5. Do not use the wire rope as a ground for welding.
Do not touch a welding electrode to the wire rope.
6. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
7. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
8. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
9. Inspect the hoist as explained in Frequent Inspection
on page 8 after installation but before use.
Operating controls
controller
Stop
Bracket
pulley
Hook
End Hook
Retract cable
(raise hook)
Extend cable
(lower hook)
25% Duty cycle
2 minutes, 30 seconds
in use
followed by
at least 7 minutes, 7 minutes,
30 seconds off
(Items 60346/60347)
20% Duty cycle
2 minutes
in use
followed by
at least 8 minutes
off
(Items 60344/60345)
This Hoist has a 20% or 25% duty cycle. This means that
it may only be run up to 2 minutes at a time
(2 minutes, 30 seconds in use for 60346/60347)
and then it must be allowed to rest for at least 8 minutes
(7 minutes, 30 seconds off for 60346/60347)
before further use.