Page 2
For technical questions, please call 1‑800‑444‑3353.
SKU 95987
Specifications
Collet Size /
Bearing Depth
3/8 IN. ~ 1/2 IN.
(1‑1/2 IN. Max. Bearing
Depth / 3/4 IN. Hex Drive)
9/16 IN. ~ 11/16 IN.
(1‑3/4 IN. Max. Bearing
Depth / 3/4 IN. Hex Drive)
5/8 IN. ~ 1 IN.
(1‑3/4 IN. Max Bearing
Depth / 3/4 IN. Hex Drive)
1 IN. ~ 1‑1/4 IN.
(2 IN Max. Bearing Depth
/ 1 IN. Hex Drive)
Slide Hammer
Weight
3 LB. with Handle
1.95 LB. without Handle
Important Safety Information
Assembly Precautions
1. Assemble only according to
these instructions. Improper
assembly can create hazards.
2. Wear ANSI‑approved safety
goggles and heavy‑duty work
gloves during assembly.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the
area during assembly.
5. Do not assemble when tired
or when under the influence
of drugs or medication.
Use Precautions
1. This product is not a toy. Do not allow
children to play with or near this item.
2. Use as intended only.
3. Inspect before every use; do not
use if parts are loose or damaged.
4. Maintain product labels and
nameplates. These carry important
safety information. If unreadable
or missing, contact Harbor Freight
Tools for a replacement.
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of
this document including
all text under subheadings
therein before set up or
use of this product.
1. After threading the proper Attachment
(3, 4, 5 or 6) onto the end of the Slide
Hammer (1) make sure the clamps of
the Attachment are completely closed.
NOTE:
To open or close the
Attachment Clamps, grasp the
Attachment head firmly and twist
the Handle (2) of the Slide Hammer.
A clockwise motion will open the
clamps, while counterclockwise
motion will close them.
2. Insert the Attachment head into the
inner diameter of the bearing.
3. Grasp the Attachment head while
turning the Handle clockwise until
the Attachment clamps open and are
are snug against the bearing lining.
4. Firmly grasp the Slide Hammer and
Handle with both hands. Spread
your feet shoulder‑width apart.
5. Gently push Slide Hammer forward.
Make sure your fingers are not in
the way of the sliding action.
6. Forcefully pull Slide Hammer backward
towards your body. Watch bearing
for movement. Bearing should pull
out evenly. If the Bearing pulls out
unevenly during this operation, stop.
