Page 8
For technical questions, please call 1-888-866-5797.
Item 63682
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
pump Set Up
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Disconnect the pump from its 12 volt power source before performing any
procedure in this section.
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the Power Cables (43) along a safe route
to reach the work area without creating a tripping
hazard or exposing the Cables to possible damage.
The Cables must reach the work area with enough
extra length to allow free movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
4. Have rags nearby to clean up any fuel spills.
5. Have multiple fully charged ABC fire
extinguishers nearby in case of fire.
6. If the Pump is not permanently installed,
set it on a stable, flat location.
General Operating Instructions
1. Make sure that the Power Switch is in the
off-position, then connect the Power Cable
Clamps to a 12 volt power supply (such as
a battery, not included). Connect the RED
Clamp to the Positive (+) terminal and the
BLACK Clamp to the Negative (–) terminal.
2. Insert the Nozzle into the destination tank.
3. Insert the intake Hose with its Strainer into the fuel
supply tank. Immerse the Strainer in the fuel fully.
4. Press the Power Switch to start the Pump.
5. Squeeze the trigger of the Nozzle to
discharge fuel into the destination tank.
Hold the Nozzle firmly during the fuel transfer.
Note:
To lock the trigger during extended pumping,
squeeze the trigger and press in on the spring-
loaded trigger lock. Then position the trigger
into one of the two recessed steps on the trigger
lock. Ease back on the trigger to lock it in place.
Do not leave the pump unattended during
operation with the trigger locked on.
To unlock,
pull slightly on the trigger to release the lock.
6. When the fuel has been transferred,
release pressure on the Nozzle trigger.
When fuel stops flowing, turn off the Pump.
7. Disconnect the Power Cable Clamps—BLACK
first, then RED—from the 12 volt power supply.
8. Remove the Nozzle from the destination
tank and place in a secure location.
9. Remove the intake Hose with its Strainer
from the fuel supply tank, allowing fuel to
drain out of the Hose before removing it.
10. Cap both supply and destination
tanks to prevent fuel spills.
11. Clean and dry all exterior parts of the Pump Body,
Hose, Nozzle, and Power Cables/Clamps.
12. Store the Pump indoors and out of reach of
children and other unauthorized persons.
