Page 6
For technical questions, please call 1-888-866-5797.
Item 63184
SAFETY
OPERA
TION
MAINTENANCE
SETUP
OPERA
TION
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Compressor Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by
children or pets to prevent injury.
2. Position the Compressor on a flat level surface.
Route the air hose along a safe route to reach
the work area without creating a tripping
hazard or exposing the air hose to possible
damage. The air hose must be long enough
to reach the work area and have enough slack
to allow free movement while working.
General Operation
1. Turn the On/Off Switch to the “OFF” position.
2. Connect the coiled Air Hose to the Compressor Hose.
a. Pull back on the collar of the Air Hose’s coupler.
b. Firmly insert the Compressor Hose
connector into the coupler.
c. Release the collar, which will snap
the connector into place.
d. Pull lightly on both hoses to ensure
a proper connection.
3. Select the desired Nozzle accessory and
attach it to the end of the Air Nozzle.
4. Turn on the car engine.
5. Attach the clamps on the Power Cord onto the 12V
automotive battery (not included) power source.
a. Connect the RED clamp of the Compressor
to the positive (+) terminal of the battery.
b. Connect the BLACK terminal of the Compressor to
a good ground source on the engine block.
WARNING! Do NOT connect it to
the other battery terminal.
Note:
Connect to 12VDC power source only.
6. Be sure the valve stem of the to be
inflated is clean and free of dirt.
7. Turn the Compressor On/Off
Switch to the “ON” position.
Note:
Turn the Compressor on before connecting
to the tire valve to prevent blowing the fuse.
8. Holding the Air Hose, connect the Nozzle
accessory to the valve stem of the to be inflated.
9. Monitor the Pressure Gauge carefully
to avoid over-inflating the item.
10. Continue inflating until the recommended
pressure is reached.
11. Turn the compressor On/Off Switch
to the “OFF” position.
12. Remove the Nozzle from the object.
13. Verify tire pressure with a tire pressure
gauge (not included), then replace the
valve cap where applicable.
14. If the tire pressure is low, repeat the
steps beginning with Step 7.
15. When finished, remove the Clamps
from the power source.
CAUTION!
The metal parts of the compressor and
hoses will become hot during use. Do not touch them.
16. Allow the Compressor to cool, then wipe
down and replace into the included storage
bag. Return the Nozzles to the small storage
bag attached to the Compressor Hose.
17. Store in a dry location.
