4
Fluid Power Car User Guide 60070 V0113
4. Place Part 5 over the plunger.
5. Place Part 3 on top of that so the two saw edges of Parts 3 and 4 face
each other. Insert the 3/8" screws from the side with the two circles.
This is the gear train assembly.
6. Using sandpaper or a file, file off any rough edges on the ends of the
axles.
7. Place a one-way bearing on the axle and notice how it will spin in only
one direction and that a tiny arrow on the side indicates this. Remove
the bearing.
8. Lay the two Part 6s on a flat surface and center the bearings inside
these. Make sure both bearings spin in the same direction.
9. Place one Part 7 over a Part 6. Pick this up and place the other Part 6 on
the other side so Part 7 is sandwiched between the other two pieces.
Make sure to keep the bearings spinning in the same direction.
10. Insert an axle through the bearings and center it. Place a Part 7 on each
side of the bearing assembly.
Steps 3-5
3
4
5
Completed assembly
3/8
"
screws
Steps 7-10
One-way
bearing
6
7
7
7
Side view
of completed assembly
Axle
