Pitco SELVRF, Руководство по устранению неисправностей и обслуживанию

Страница: 10 / 26

BEFORE SERVICING, REFER TO PAGE 3 AND 4 OF THIS DOCUMENT FOR IMPORTANT NOTICES
L22 - 405 RO 10
COMPUTER DISPLAYS
•

After every filter cycle, the equipment will be put into an energy savings mode. This mode will drop the set
temperature to the programmed setback temperature.

To enter energy save mode, press and hold the thermometer key unit “ ” is displayed.

To exit the energy save mode, press the thermometer key once and the unit will then heat to the correct set
temperature for cooking products.
•

Quick filter is when the unit will drain the oil into the filter pan and then fill the tank. This process usually takes less
than two minutes.
•

This is the end of day filter. It is the same process as the quick filter except the oil will run through the filter paper for
a longer time for a more thorough cleaning process.
•

This indicates that the filter pan in not installed or not installed properly. This message will also display if the front
door is open. Make sure the filter pan is installed properly and the front door is closed before trying to filter again.
•

The filter pan may still have oil in it or there is debris holding the filter pan float in a raised position. Remove the oil
and/or debris before trying to filter again.
•

The filter pan has not properly sensed oil draining into it from the fry pot during a filter cycle. If the drain is open and
no oil is entering the filter pan, use the provided drain tool to clear the drain. Once the oil drains into the filter pan,
the filter process will automatically restart.
•

The oil is returned to the fry tank from the filter pan to finish the filter cycle. If the filter pan is not sensed empty
within a predetermined time, the system assumes there is a pump issue.

Check to make sure the pre - filter screen is free of any debris and is screwed in and tight. Finger tight is ok.
Also check that the white O - ring is in place on the pre - filter screen.

Check the white On/Off switch behind the door towards the top of the cabinet is in the On position. This is
the circuit breaker for the pump motor.
•

The filter pan was sensed as not in place or the door was opened during a running filter cycle. This error will shut
down all operation and the operator must intervene to finish the filter cycle.

Check to make sure the filter pan did not get pulled out from the fryer while the fryer was in a filter mode.
Replace the filter pan or push the filter pan back in place.

Verify the door is properly latched.

Once the filter pan has been put back into the proper position and the door closed, you will need to manually
return the oil to the fry pot using the computer interface.
•
Press and hold the middle filter button until the display shows “ ”
•
Press the “ L ” key.
•
Press the “6” key to turn on the filter pump.
•
Once the oil is returned, press the “6” key again to turn the filter pump off.
•
Turn the fryer off and back on. The unit is now ready for use.