PITBULL X24-36, Руководство оператора

Страница: 37 / 71

37
8.10 Motor oil
The engine oil that is suitable for the Pitbull is 15W40 engine oil. The oil level can be checked with
the dipstick (1). Check the oil level according to the maintenance schedule. The dipstick uses dashes
to show the minimum and maximum levels for the engine oil level. The engine oil can be topped up
by unscrewing the filler cap (2). The oil can be drained via the drain plug (3). Collect the oil. The drain
plug can be reached by loosening the cover plate (4) on the underside of the machine. Wait 5 to 10
minutes after the engine is switched off before draining the oil; warm oil eases the flow but very hot
oil can cause injury. Tighten the drain plug securely before topping up with fresh oil. To change the
engine oil, 4.6 litres of fresh oil is required.
8.11 Coolant
WARNING! Do not open the cap of the combination cooler if the coolant can be hot. Due
to the pressure, the hot liquid may escape.
The coolant that is used is XLC, which can be used throughout the year in a 50% mixing ratio with
water, and thereby provides protection up to -40 degrees Celsius. Only top up the coolant level when
the engine is cold. The amount of coolant can be checked and topped up by loosening the cap on the
right-hand side of the combination cooler. There is a vent valve in the cap to protect the cooling
system against overpressure. For this reason, the combination cooler must not be filled up to the
cap.
To drain old coolant, unscrew the drain plug (1) on the
combustion engine. It is located on the right-hand side
of the engine, to the right of the engine oil filter.
Collect the old coolant and flush the cooling system
with fresh coolant so that no dirt is left behind. Re-
tighten the drain plug before topping up the coolant.
To replace the coolant, 7.5 litres is required.