Piranha IRONWORKER P90, Руководство по эксплуатации

Страница: 19 / 53

Piranha Ironworker P90 19
Bending Attachment Alignment
The alignment of the bending punch and bending die should be accomplished by the
following manner. Reference pages 31 and 38.
1. Slide the bending punch assembly on the dovetail-mounting shoe. The front edge of
the bending dovetail slide should be even with the mounting shoe
2.
Tighten the locking shoe by turning the cap screw clockwise (requires 3/8” Allen
wrench). This locks the bending punch assembly firmly in place.
3. Place the bending base holders on the platen table over the setscrews. Do not tighten
flanged nuts.
4. Place the four-way bending die into the bending base holder with the proper width die
opening on the top.
5. Switch the front control box toggle switch (Reference f
igure A) to the “OFF” position
and disconnect the foot switch from the receptacle.
6. Start the machine. Using the front control box joystick in the jog down mode
(Reference figure C), move the beam downward.
7. When contact between the bending punch and the bending die block opening is made,
the bending die block will center itself.
8. Using the wrench supplied with the machine, tighten flanged nuts on the setscrews to
hold the base assembly firmly to the platen.
9. Set the limit switches to control the length of stroke (reference procedures previously
listed).
10. Start operation.