Piranha IRONWORKER P90, Руководство по эксплуатации

Страница: 17 / 53

Piranha Ironworker P90 17
Stripper Attachment Alignment
The alignment of the stripper should be accomplished in the following manner. Reference
pages
31 and 36 .
1. Slide the punch stripper assembly on the dovetail-mounting shoe.
2.
Tighten the locking shoe by turning the cap screw clockwise (requires 3/8” Allen
wrench). This locks the stripper assembly firmly in place.
3. Remove the coupling nut from the punch stem using the coupling wrench.
4. Insert the punch in the coupling nut and tighten on the punch stem using the coupling
wrench.
5. Insert the female die in the die block.
6. Tighten
the setscrew against the female die (requires 3/16” Allen wrench).
7. Slide the die block around the setscrews on the platen table. Do not tighten the flanged
nuts.
8.
Switch the front control box toggle switch (reference Figure "A") to the “OFF” position.
Disconnect the foot switch from the receptacle.
9. Start the machine. Use the front control box joystick in the jog down mode (reference
Figure "C"), to move the beam downward. Stop beam movement when the bottom of
the stripper foot is approximately 1/8" above the die block.
10. Align the punch and die visually and by hand movement of the die block. Jog down
again slightly and align. Continue this procedure until the punch has passed through
into the die.
11. Using the wrench supplied with the machine, tighten the flanged nuts on the setscrews
to hold the die block firmly to the platen table.
12. Set the limit switches to control the length of stroke Reference previous page.
13. Start operation.