The GSX eForce grip frame is capable of high rates of fire and an agitating hopper such as an
Extreme Rage Overdrive, VL Revolution, Halo, or Evolution 2 is recommended for better performance.
SEAR RELEASE SLIDE
:
The sear release slide is located on the left
hand side of the eForce grip frame. To reinstall the bolt/block/hammer
assembly, push the sear release slide up before the hammer comes in
contact with the sear. That will allow the bolt/block/hammer assembly
to slide easily into the marker.
INSTRUCTIONS FOR USE
ON/OFF BUTTON:
The on/off is the silver button located on
the left hand side of the gripframe. Push it once and the red on/off
indicator will then light up. Push the on/off button again to turn it
off. The frame should be left off when not using the marker or you
will drain the battery.
WARNING:
Never use water to clean the marker, or you run the risk of damaging the electronic trigger frame.
Cocking Rod
Velocity
Adjustment
Screw
On/Off Button
Sear Release
Charge Port
Gas Thru Grip
Drop Forward
High Performance 2-Piece Barrel
10º Bottom Line
Adapter
GSX BATTERY:
The GSX comes with a 9 volt rechargeable battery. You must charge it for a full 22 hours before initial use since the it does not come fully
charged. For best long term battery life, repeat this process every time it is drained. You can also use a regular 9 volt battery with this frame if your rechargeable
battery is dead or if you want to play with the frame right away. You will need to remove the right grip panel when you need to replace it.
On/Off Indicator
WARNING:
PMI RECOMMENDS USING THE 9V RECHARGEABLE BATTERY PROVIDED FOR OPTIMAL PERFORMANCE. DO NOT
USE THE BATTERY CHARGER WHEN USING ANY NON-RECHARGEABLE BATTERY.
GSX
BURST BUTTON
Press the Burst Button once to turn the marker on 3
Shot Burst. Press the Burst Button again to turn the frame to 6 Shot Burst.
Press the Burst Button again to turn the frame to 9 Shot Burst. Press the
Burst Button again to turn it back to semi-auto.
FULL AUTO BUTTON
Press the Full Button once to turn the frame to
Full Auto. Press the Full Button again to turn it back to semi-auto.
eFORCE BATTERY
The eForce frame comes with a 9 volt
rechargeable battery. You must charge it for a full 22 hours with the
marker turned off before initial use since it does not come fully
charged. For best long term battery life, repeat this process every
time it is drained. You can also use a regular 9 volt battery with this
frame if your rechargeable battery is dead or if you want to play
with the frame right away. You will need to remove the right grip
panel when you need to replace it. A blinking on/off indicator light
means your eForce frame needs to be charged right away. Always
charge with the marker turned off.
TOURNAMENT LOCK SWITCH
The Tournament Lock Switch
enables you to play in a tournament or at a field that does not allow full
auto and burst modes by restricting the marker to semi-automatic only. All
eForce frames come with the Tournament Lock off so you can immediately
put the marker in full auto or burst mode. See Piranha manual (5.3) page
32 or Piranha manual (5.1) page 28.
