MAINTANACE / FILTER REPLACEMENT
CLEANING/REPLACING FOAM AND HEPA FILTERS
To remove/replace the filter (either foam or HEPA) from the vacuum, please
follow these steps:
a. Remove the Filter cover from the vacuum handle/housing.
b. Remove the Filter from the vacuum handle/housing.
Clean the Filter as follows:
Foam Filter Cleaning:
Wash the Foam Filter in warm, soapy water until clean. Allow the Foam
Filter to dry before reinserting into the Handle/Housing.
NOTE:
Use only mild soap. Avoid detergents, chemical cleaners or solvents
as these may damage the plastic.
HEPA Filter Cleaning:
Use your finger to lightly clean the paper surface of the HEPA Filter, clearing
off any dirt, dust and hair.
NOTE 1: Do not wash the HEPA Filter. Water will permanently damage the filter.
NOTE 2: Under normal household use, the HEPA Filter will last 6 – 12 months
c. Insert either side of the Clean Filter (or if necessary a new filter) into the Handle/Housing then
snap-on the Filter Cover and reattach the Bowl to the Handle/Housing (making sure that the
Pre-Filter is inserted into the Bowl).
NOTE: Filters should be replaced periodically to provide best performance or when the filter has
been damaged.
CLEANING THE VACUUM HOUSING
Clean the vacuum’s Handle/Housing with damp cloth. Never immerse the Handle/Housing in water.
