Pioneer XW-NAS3, Руководство по эксплуатации

Страница: 14 / 60

Bluetooth® ADAPTER for Wireless Enjoyment of Music 04
14
En
1 Switch the unit into standby and connect
Bluetooth ADAPTER to the ADAPTER PORT
located in the rear panel.
2 Press

STANDBY/ON.
3 Press INPUT to switch to Bluetooth
ADAPTER input mode.
1
The Bluetooth ADAPTER indicator blinks.
Setting the PIN code
Set this unit’s PIN code to the same setting as
that for the
Bluetooth wireless technology
device used. Supported PIN code setting
values include 0000, 1234 or 8888.
• Default setting: 0000
1 Switch the unit into standby.
2 Press and hold  for three seconds.
The Bluetooth ADAPTER indicator will flash,
and the PIN code will be changed. The number
of flashes corresponds to the newly set PIN
code as follows:
• 1 flash: 0000
• 2 flashes: 1234
• 3 flashes: 8888
Repeat step 2 until the PIN code is reset to the
value desired.
Pairing
Bluetooth ADAPTER and
Bluetooth wireless technology
device
“Pairing” must be done before you start
playback of
Bluetooth wireless technology
content using Bluetooth ADAPTER. Make sure
to perform pairing first time you operate the
system or any time pairing data is cleared.
“Pairing” is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
2
For more details,
see also the operating instructions of your
Bluetooth wireless technology device.
1 When the
Bluetooth
ADAPTER indicator
blinks, press

.
The Bluetooth ADAPTER indicator will blinks
fast, and the unit will enter the pairing standby
mode.
2 Switch on the Bluetooth wireless
technology device that you want to make
pairing, place it near the system and set it
into the pairing mode.
Pairing begins.
3 Check to see that the
Bluetooth
ADAPTER
is detected by the
Bluetooth
wireless
technology device.
The Bluetooth ADAPTER indicator lights when
Bluetooth wireless technology device is
connected.
The Bluetooth ADAPTER indicator blinks slowly
when Bluetooth wireless technology device is
not connected. In this case, perform the
connection operation from the side of the
Bluetooth wireless technology device.
Note
1 When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT , Bluetooth ADAPTER input mode cannot be selected even
if
INPUT
is pressed.
INPUT
2 • Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
INPUT
XW-NAS3_CUXJ.book 14 ページ ２００９年１２月２４日 木曜日 午後１時４７分